Single wire high speed paper covering machine configuration Acceptance standard: pitch control, rotary speed control, the temperature of machinery parts can not exceed 40℃ within half an hour after switching on the paper covering machine, Electric circuits, transmission parts, pneumatic components, protective enclosure, safe lock of paper lapping tray. Brief Instruction: this machine is fully closed lapping avoiding the dust to enter into insulating papers. Tensile force is a mechanical constant tension, an apron wheel is used for drawing without any slide to guarantee the synchronous transmission in speed. The synchronization serrate belt is used to transmit the whole machine to guarantee the lapping pitch of multi-layer papers not to float. It adopts the paper-breaking automatic stop device and the electric stepless transmission controller to adjust the lapping pitch to assure the overlapping degree. The take up unit adopts a torque motor, polished rod pay off and electromotion device for take the spool up and down, decreasing the labor intensity. Applicable range: Width 4～20mm Thickness: 1～15mm, Section: 0～120mm² The ratio of Width / thickness: 0.4～12 Covering head: caged type Two sets of pay off units stand in vertical and horizontal direction respectively and match with the rolling alignment and half-hard line device. Cleaning: four electric nylon brushes, arranging in 90 degrees Adopting four-sides cleaning, cleaning the smears, oxidation layer, small burrs on the surface of side a and side b of naked copper wire
